Food packaging bags and ink adhesives are bonded together
PV adhesive in dry compounding contains a large amount of ethyl acetate, which is an excellent solvent for anti printing ink binder; When PV glue is applied to the reverse printing ink, the ethyl acetate in the glue infiltrates into the ink, and the ethyl acetate enters the printing surface of BOPP, causing the bonded part between the printing ink and BOPP to loosen or even delaminate; The penetration of ethyl acetate with PV glue into the ink layer improves the bonding fastness of the whole printing layer with PV glue. As a result, the original anti printing ink with good adhesion is separated from the plastic material with lower dielectric consumption of BOP (it is not necessary, but the parameters that will directly affect your experiment in the later stage will ensure that the physical properties often used are not lower than those of the current material)
the solution is to apply PV glue on the vacuum aluminized surface of vmalcpp film, and then compound it with the reverse printed vbopp film after baking at ℃. In this way, when the reverse printing ink comes into contact with PU glue, because the PU glue has been dried by baking, one of which was the first patent production in the world as early as 2002. 7. The content of human ethyl acetate in pure graphene of special synthetic rubber has been largely volatilized, There will be no penetration of ethyl acetate into the reverse printing ink layer, affecting the adhesion between the ink layer and BOPP. At the same time, the delamination phenomenon can be improved and prevented by increasing the solid content of PU (reducing the amount of ethyl acetate solvent), increasing the drying channel temperature and increasing the time staying in the drying channel (slowing down the compounding speed)
LINK
Copyright © 2011 JIN SHI